Élément de bridage expansible MiteeBite ID Xpansion (590-38400)

Low Profile

Ideal for Secondary Operations on Lathe Parts

Easily Machined to Size on Lathe or Mill

Allows More Parts Per Workcube or Fixture Plates

Excellent for Palletised Setups

Screw Coated to Prevent Seizing for Increased Accuracy

Clamp Body Made of Mild Steel for Machinability

Tighten with Hex Key or Hydraulic Pull Cylinders (Screw protrudes from bottom of base)

The WDS ID Xpansion™ clamp is the ideal way to hold parts on an inside diameter for multiple machining on a vertical machining centre or a horizontal machining centre. These machinable clamps are produced in 10 sizes and can hold internal diameters from 4.1mm to over 103mm. The clamps use a heat treated tapered screw for expansion.

The larger diameter of the clamp is held to a close tolerance for precision locating in a machined pocket on work cubes and fixture plates.

The customer machines the mild steel clamp to match the bore of the part ensuring proper fit. Often times the clamps can be remachined for different size jobs. One of the benefits of these low-profile clamps is holding many lathe parts, for secondary machining, on one compact set up. They are quickly tightened with a hex key, torque driver or can be mated to hydraulic pull cylinders for automation.

'F' dimension can be machined down to 'G' dimension

'H' Mounting screws included (3)

MACHINING AND INSTALLATION

Expand clamp approximately 0.1mm over relaxed diameter and machine to fit workpiece bore, either on lathe or mill.

If machining the clamp on a lathe use the nut provided, on the back of the clamp, to tighten the tapered screw. This nut is used only to machine the clamp.

Machine a pocket, in the fixture, for the close Tolerance “E" dimension and drill and tap mounting holes per “H" column. Drill and tap a hole from the “I" column in the centre of the pocket for the tapered screw.

A recessed dowel pin may be installed into the flange for additional rigidity if required.